A$3,019.50 Inc GST
In Stock

DPA 4017B-R directional mic with Rycote boom mount, suspension, windshield, windjammer, accessories

At just 210 mm (8.3 in) and 68 g (2.4 oz), this mic is one of the shortest and lightest shotgun condenser microphones available. At the same time, it offers impressive accuracy, clarity and musicality. The mic is immune to RF emission and the 19 mm (0.75 in) condenser cartridge is capable of handling peak SPLs of 152 dB before clipping. It also withstands use in very humid environments with ease.

The d:dicate™ 4017B Shotgun Microphone features two onboard filters. They are activated via an ingenious switching ring design. With a simple twist of two sturdy rings, engineers can implement a high-frequency boost that adds a 4 dB shelf at 8 kHz. This compensates for hi loss when used with windjammers. A first-order bass roll-off below 120 Hz minimizes handling and wind noise. A permanent third-order high-pass filter at 50 Hz effectively removes unwanted low frequency disturbance from handling and wind noise.

This solution is available with Rycote® Windshield and suspension system – a fully-packed and ready-to-go solution.

Specifications

  • Directional pattern Supercardioid, lobe-shaped
  • Principle of operation Pressure gradient, with interference tube
  • Cartridge type Pre-polarized condenser
  • Frequency range 20 Hz - 20 kHz, permanent third order high pass filter at 50 Hz
  • Frequency range, ±2 dB, at 60 cm (23.6 in) 70 Hz - 18 kHz with typ. 3 dB soft boost at 15 kHz
  • Sensitivity, nominal, ±2 dB at 1 kHz 19 mV/Pa; -34.4 dB re. 1 V/Pa
  • Equivalent noise level, A-weighted Typ. 13 dB(A) re. 20 µPa (max. 15 dB(A))
  • Equivalent noise level, ITU-R BS.468-4 Typ. 24 dB (max. 26 dB)
  • S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL) Typ. 81 dB(A)
  • Total harmonic distortion (THD) < 1% up to 137 dB SPL peak
  • Dynamic range Typ. 124 dB
  • Max. SPL, peak before clipping 138 dB
  • Switchable attenuator, filters etc. High boost: +4 dB at 8 kHz. Low cut: First order filter, below 120 Hz
  • Output impedance 100 Ω
  • Minimum load impedance 2 kΩ
  • Cable drive capability 100 m (328 ft)
  • Output balance principle Signal balanced
  • Common mode rejection ratio (CMRR) > 40 dB
  • Power supply (for full performance) 48 V Phantom power (± 4 V)
  • Current consumption 4.5 mA
  • Connector XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: signal - phase
  • Color Matte black
  • Weight 68 g (2.4 oz)
  • Microphone diameter 19 mm (0.75 in)
  • Capsule diameter 19 mm (0.75 in)
  • Microphone length 212 mm (8.3 in)
  • Maximum output voltage, RMS 2.0 V
  • Polarity +V at pin 2 for positive sound pressure
  • Temperature range -40°C to 45°C (-40°F to 113°F)
  • Relative humidity (RH) Up to 90%

(DPA.4017B-R)

SKU DPA.4017B-R
Brand DPA

Others Also Bought


Lectrosonics SRC-V2/C1

Lectrosonics SRC-V2/C1

A$3,712.50

Lectrosonics ALP650/LE

Lectrosonics ALP650/LE

A$984.50

DPA VO4099T

DPA VO4099T

A$815.10

Sennheiser HD380-PRO

Sennheiser HD380-PRO

A$203.50

Sennheiser MKH8060

Sennheiser MKH8060

A$1,705.00

Ambient ARAYS

Ambient ARAYS

A$2,486.00

Ambient QWB

Ambient QWB

A$187.00

Voice Technologies 403

Voice Technologies 403

A$434.50


More From This Category


Sennheiser AMBEO Mic

Sennheiser AMBEO Mic

A$2,722.50

Sennheiser MKH8070

Sennheiser MKH8070

A$2,068.00

Sennheiser MKH8060

Sennheiser MKH8060

A$1,705.00

Sennheiser MKH8020

Sennheiser MKH8020

A$1,303.50

Sennheiser MKH70

Sennheiser MKH70

A$2,304.50

Sennheiser MKH50-P48

Sennheiser MKH50-P48

A$1,881.00

Sennheiser MKH418-S

Sennheiser MKH418-S

A$1,914.00

Sennheiser MKH416-P48U3

Sennheiser MKH416-P48U3

A$1,078.00